7/29/2023 0 Comments Pulsar lost colony manual![]() ![]() ![]() Lights - Manages both the lights inside of the ship, and those of the turrets.Air Filter - Filters out smoke and toxins from the ship.Oxygen Gen - Powers the ship's life support system.Atrium Healing - Slowly heals crewmembers near the Atrium.This will automatically be routed to the main reactor and act as a boost in power. Turning systems OFF will give the auxiliary reactor a surplus of power. Leaving them on will ensure all of the auxiliary systems remain functional. These systems are not connected to the main reactor and its temperature.īy default, these settings will be ON. ![]() Limiting this will slow the recharge and reload rate of any ship turrets.įound in the engineering room and the bridge, this screen's purpose is to expose the functions and settings of all the auxiliary systems aboard the vessel. Weapons - Controls the amount of power the weapons systems can use.Limiting this will slow the shield regeneration process. Shields - Controls the amount of power the shield generator can utilize to regenerate any damage to the shields.Limiting reduces sensor range, decrease the effectiveness of any active scans, as well as increase the amount of time it takes to perform one, and slow jump calculation. Science Lab - Controls the amount of usable power for the sensors.Limiting reduces maximum speed, maneuverability and slows the charging of the warp drive. Engineering - Controls the amount of power that can be sent to the thrusters and warp drive.Setting limits scales the efficiency of any system connected to that specific conduit. The white triangle indicates the power limit of each component. The Engineer can select the limit of how much power each conduit can use by clicking and dragging in the bar to move the white triangle above it. The bars fill with blue based on how much power is being allocated. Each of the four conduits will attempt to take a piece of that bar for their own systems. Simply put, the length of the bottom bar is the total amount of energy the entire ship can use. The bottom bar reflects the total usage of the installed reactor. The four conduits are the top bars in the following order: Engineering, Science, Shields, and Weapons. This gives the engineer a quick understanding of how much power every conduit may require. The most powerful of the 4 conduits will have the largest bar, and the rest will scale proportionally to that specific conduit. The size of the bars depends on how powerful the currently installed ship components are. This screen is composed of a temperature gauge and 5 horizontal bars that fill from left-to-right. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |